iRobot Looj - Manual (Page 10)

1 iRobot Looj Owner’s Manual www.irobot.com 1
Troubleshooting
Refer to the chart below to resolve Looj’s problem. If the problem is not
resolved, visit
www.irobot.com/support (page 20).
observation Likely Cause What to do
Remote transmission
light does not light up
on the remote. Batteries were inserted incorrectly
or have depleted. Power may not
be on. Check the battery orientation or replace with
fresh batteries. Switch the remote power
button to the “on” position.
Robot is not
responding to the
remote control
handle. Robot power is off or there is
radio interference between the
remote control handle and robot. Check to see that both power buttons are on
and both robot and remote control handle
lights are flashing when a remote button is
pressed. If not, try to improve reception by
raising the remote control handle above the
height of the gutter while operating.
Auger will not insert
into robot. Insertion hole is clogged. Clean out hole with toothpick or forced air.
Auger stops spinning
and loud clicking
sound is heard. Clutch has slipped on Auger. Immediately turn off the auger and back up the
robot away from any debris. Try spinning the
auger in a clear area to test it.
Auger is spinning but
robot is not moving.
Clicking sound is
heard. Robot movement has stopped to
protect the robot track motors.
The clutch has slipped on the
robot track wheels. Retrieve robot, clean the wheels and test it
on the ground to make sure it is operating
properly before placing back into the gutter.
storing Looj
Store iRobot Looj in a cool, dry place. After charging store Looj and its battery
between 50˚ and 80˚ F (10˚-26˚ C). Excessive heat or cold may reduce battery
life and product performance. For best results, we recommend removing both
the battery pack from the robot and the batteries from the remote control
handle when the product is stored.
indicator Lights
Robot Power Light What it means
Solid Red Battery is low. Turn off auger immediately and recharge battery.
Blinking Red Battery is low and robot is receiving data (commands) from the
remote. Turn off auger immediately and recharge battery.
Solid Green Power is on, battery level is ok.
Remote transmission Light What it means
Solid Green Power is on.
Blinking Green Remote control is sending data (commands) to the robot.