Akai Ewi4000s - Manual (Page 48)

46
* “CP” (Control Protocol) is set by default to “on,” which adds an extra check to the SysEx data. If you
experience problems with SysEx communications, press and hold the SETUP BUTTON, press the HOLD
BUTTON or OCTAVE BUTTON until “CP” appears on the PROGRAM / DATA DISPLAY, then release the
SETUP BUTTON. Press the HOLD BUTTON or OCTAVE BUTTON so the PROGRAM / DATA DISPLAY
reads “OF,” then press the SETUP BUTTON again.
PARAMETER RANGE DEFAULTS
UPDATE
CONTROL PROTOCOL *
ON
DEFAULT
OFF