ADC PowerWorx Power Distribution Products - Manual (Page 26)

ADCP-80-545 • Issue 3 • March 2006
Page 20
© 2006, ADC Telecommunications, Inc.
Figure 13. Input Power Connections
3.7 Protective Cover Installation/Removal
Install the rear protective covers, shown in Figure 14 , when all the wiring and tests are
completed. Both the input and output terminal covers snap into place over the terminals. If the
protective covers are lost or damaged, contact ADC for replacement (refer to
Section 7,
Customer Information and Assistance ).
Figure 14. Protective Cover Installation/Removal
DETAIL DRAWING OF
INPUT POWER
CABLE CONNECTIONS
17933-A
TIGHTEN INPUT TERMINAL
NUTS TO 32 POUND FORCE INCHES
(3.6 NEWTON METERS) OF TORQUE
17937-A
COVERS FOR
OUTPUT POWER
TERMINALS
COVER FOR
INPUT POWER
TERMINALS
COVER FOR
INPUT POWER
TERMINALS