MSI FM2-A85XMA-E35 - Manual (Page 46)

2-6
BIOS Setup
PCI Latency Tmer
Controls how long each PCI devce can hold the bus before another takes over.
When set to hgher values, every PCI devce can conduct transactons for a longer
tme and thus mprove the effectve PCI bandwdth.
ACPI Settngs
Press <Enter> to enter the sub-menu.
ACPI Standby State
Specfies the power savng mode for ACPI functon
[S1] Sleep Mode. Hardware remans on.
[S3] Suspend to RAM. Turns off hardware. (Recommended)
Power LED
Configures how the system uses power LEDs on the case to ndcate sleep/
suspend state.
[Sngle] The power LED turns off durng the sleep/suspend mode.
[Dual] The power LED changes ts color to ndcate the sleep/suspend
state.
[Blnkng] The power LED blnks to ndcate the sleep/suspend state.
Integrated Perpherals
Press <Enter> to enter the sub-menu.
Onboard LAN Controller
Ths tem allows you to enable/ dsable the onboard LAN controller.
LAN Opton ROM
Ths tem s used to decde whether to nvoke the Boot ROM of the onboard LAN.
Network Stack
Ths tem s used to enable/ dsable UEFI network stack.
Ipv4 PXE Support
Ths tem appears when you set “Enabled” n [Network Stack] field and s used to
enable/ dsable the Ipv4 PXE boot support.
Ipv6 PXE Support
Ths tem appears when you set “Enabled” n [Network Stack] field and s used to
enable/ dsable the Ipv6 PXE boot support.
SATA Mode
Ths tem s used to specfy RAID/ IDE/ AHCI mode for SATA port.
Important
Wndows XP s not natvely supported to be nstalled n the storage devce wth AHCI
mode. If you stll prefer to nstall Wndows XP as the operatng system, please refer
to Appendx Install Wndows XP Notes.
You cannot swtch between AHCI and IDE f you already have your operatng system
nstalled.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
•
•