MSI Z68A-GD80 (G3) Manual - Manual (Page 58)

2-12
BIOS Setup MS-7672
Chapter 2
BIOS Setup MS-7672
Chapter 2
tWR
Determnes mnmum tme nterval between end of wrte data burst and the start of a
pre-charge command. Allows sense amplfiers to restore data to cell.
tWTR
Determnes mnmum tme nterval between the end of wrte data burst and the start
of a column-read command; allows I/O gatng to overdrve sense amplfies before
read command starts.
tRRD
Specfies the actve-to-actve delay of dfferent banks.
tRTP
Tme nterval between a read and a precharge command.
tFAW
Ths tem s used to set the tFAW (four actvate wndow delay) tmng.
tWCL
Ths tem s used to set the tWCL (Wrte CAS Latency) tmng.
tCKE
Ths tem s used to set the Pulse Wdth for DRAM module.
tRTL
Ths tem s used to set Round Trp Latency settngs.
Advanced Channel 1/ 2 Tmng Configuraton
Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng
for each channel.
Spread Spectrum
Ths functon reduces the EMI (Electromagnetc Interference) generated by modulatng
clock generator pulses.
Important
If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
Remember to dsable Spread Spectrum f you are overclockng because even a slght
jtter can ntroduce a temporary boost n clock speed whch may just cause your over-
clocked processor to lock up.
VDroop Control
Load lne droop controls the stream of current to the CPU.
[Auto] Automatcally sets values for maxmum stablty.
[Low VDroop] Provdes less fluctuaton (better for overclockng).
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
•
•
•
▶