Front panel connector: jfp1, Chassis intrusion connector: jci1, En-13 – MSI Wind Board 330 User Manual
Page 22
En-13
E
n
g
li
s
h
PIN
SIGNAL
DESCRIPTION
1
HD_LED +
Hard disk LED pull-up
2
FP PWR/SLP
MSG LED pull-up
3
HD_LED -
Hard disk active LED
4
FP PWR/SLP
MSG LED pull-up
5
RST_SW -
Reset Switch low reference pull-down to GND
6
PWR_SW +
Power Switch high reference pull-up
7
RST_SW +
Reset Switch high reference pull-up
8
PWR_SW -
Power Switch low reference pull-down to GND
9
RSVD_DNU
Reserved. Do not use.
JFP1 Pin Definition
Front Panel Connector: JFP1
This connector is for electrical connection to the front panel switches and LEDs. The
JFP1 is compliant with Intel
®
Front Panel I/O Connectivity Design Guide.
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will record
this status and show a warning message on the screen. To clear the warning, you
must enter the BIOS utility and clear the record.
JCI1
2
1
GND
CINTRU
1
2
9
10
JFP1
HDD
LED
Reset
Switch
Power
LED
Power
Switch
+
+
+
-
-
-