MSI Wind Board 230 User Manual
Page 16
2-3
Hardware Setup
Memory
The DIMM slot is used for installing memory module.
For more information on compatible components, please visit
http://www.msi.com/
index.php?func=testreport
DDR2
240-pin, 1.8V
64x2=128 pin
56x2=112 pin
Installing Memory Modules
1. The memory module has only one notch on the center and will only fit in the right
orientation.
2. Insert the memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the DIMM slot. The plastic
clip at each side of the DIMM slot will automatically close when the memory module
is properly seated.
3. Manually check if the memory module has been locked in place by the DIMM slot
clips at the sides.
Important
You can barely see the golden finger if the memory module is properly inserted
in the DIMM slot.
Volt
Notch
Important
- DDR2 memory module is not interchangeable with DDR and the DDR2 stan-
dard is not backwards compatible. You should always install DDR2 memory
module in the DDR2 DIMM slot.