MSI RS482M2-IL/L - Manual (Page 55)

3-20
MS-7093 M-ATX Mainboard
these modes: Suspend Mode and HDD Power Down. There are three options for
power management:
Min Saving Minimum Power Management. Suspend Mode=1 Hour
Max Saving Maximum Power Management. Suspend Mode=1 Min
User Define Allows end users to configure each mode separately.
HDD Power Down
If HDD activity is not detected for the length of time specified in this field, the hard disk
drive will be powered down while all other devices remain active. Settings are
[Disabled] and [1] through [15] Min.
Video Off Option
This setting is used to control the mode in which the monitor will shut down. Setting
options:
[Always On] Monitor remains on during power-saving modes.
[Suspend -> Off] Monitor blanked when system enters Suspend mode.
Video Off M ethod
This determines the manner in which the monitor is blanked.
[V/H SYNC+Blank] This selection will cause the system to turn off
the vertical and rizontal synchronization ports
and write blanks to the video buffer.
[Blank Screen] This option only writes blanks to the video buffer.
[DPMS Support] Initial display power menagement signaling
MODEM Use IRQ
This setting names the interrupt request (IRQ) line assigned to the modem (if any) on
your system. Activity of the selected IRQ always awakens the system. Setting options:
[3], [4], [5], [7], [9], [10], [11], [NA].
Soft-Off by PWRBTN
This feature allows users to configure the power button function. Settings are:
[Instant-Off] The power button functions as a normal power-on/-
off button.
[By HardW are] W hen you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer is
turned off.
Wake Up by PME
W hen setting to [Enabled], the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event). Setting
options: [Enabled], [Disabled].
PowerFail Status
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Setting options: [Always Off], [Always On], [Hardware Strap], [Previous].