MSI E350IS-E45 - Manual (Page 20)

20
Security
use this menu to set supervisor and user passwords.
Boot
use this menu to specify the priority of boot devices.
Save & exit
this menu allows you to load the BioS default values or factory default settings
into the BioS and exit the BioS setup utility with or without changes.
oC
Current CPu / dRaM Frequency
these items show the current clocks of CPu and Memory speed. Read-only.
dRaM Frequency
this setting controls the ratio of memory frequency to enable the memory to run at
different frequency combinations.
dRaM timing Mode
Select whether dRaM timing is controlled by the SPd (Serial Presence detect)
eePRoM on the dRaM module. Setting to [auto] enables dRaM timings and the
following “advanced dRaM Configuration” sub-menu to be determined by BioS
based on the configurations on the SPd. Selecting [Manual] allows users to con-
figure the dRaM timings and the following related “advanced dRaM Configura-
tion” sub-menu manually.
advanced dRaM Configuration
Press <enter> to enter the sub-menu. in this sub-menu you can adjust the ad-
vanced dRaM timing.
Command Rate
this setting controls the dRaM command rate.
tCL
this controls the CaS latency, which determines the timing delay (in clock
cycles) before SdRaM starts a read command after receiving it.