MSI MS-9656 series - Manual (Page 23)

2-11
Hardware Setup
Floppy Disk Drive Connector: FDD1
This connector supports 360KB, 720KB, 1.2MB, 1.44MB or 2.88MB floppy disk drive.
IDE Connector: J_IDE1
This connector supports IDE hard disk drives, optical disk drives and other IDE devices.
Connector
FDD1
J_IDE1
Important
If you install two IDE devices on the same cable, you must configure the
drives separately to master / slave mode by setting jumpers. Refer to IDE
dev ic e
’s documentation supplied by the vendors for jumper setting
instructions.