Jumper, Vga jumper: j_vga_en1, Clear cmos jumper: j_cmos1 – MSI MS-9656 series User Manual
Page 30: Important, Bios recovery jumper: j_boot3
2-18
MS-9656 Server Board
VGA Jumper: J_VGA_EN1
This jumper is used to enable or disable the onboard VGA controller.
Clear CMOS Jumper: J_CMOS1
There is a CMOS RAM onboard that has a power supply from an external battery to
keep the data of system configuration. W ith the CMOS RAM, the system can auto-
matically boot OS every time it is turned on. If you want to clear the system configuration,
set the jumper to clear data.
Jumper
J_CMOS1
1
Important
You can clear CMOS by shorting 2-3 pin while the system is off. Then return
to 1-2 pin position. Avoid clearing the CMOS while the system is on; it will
damage the mainboard.
1
3
Disable
Enable
1
3
J_VGA_EN1
1
BIOS Recovery Jumper: J_BOOT3
Users can short connect pin#2-3 to recover the system BIOS with a Recovery
Floppy. W hen the system is done with the job, the buzzer will beep to remind the user
to set the jumper to its normal state (pin#1-2 short connected).
Normal
1
3
Recovery
1
3
J_BOOT3
1
Keep Data
1
3
Clear Data
1
3