MSI MS-9297 - Manual (Page 69)

BIOS Setup
▍
MS-9297
4-17
BIOS Setup
▍
MS-9297
Remote Access Configuration
Remote Access
The settng enables/dsables the remote access functon. When set to [En-
abled], users may configure the following settings for remote access type and
parameters.
Serial Port Number, base Address, IRQ, Serial Port Mode
Use these settings to configure ports for remote access.
Flow Control
Flow control s the process of managng the rate of data transmsson between
two nodes. It’s the process of adjusting the flow of data from one device to an-
other to ensure that the recevng devce can handle all of the ncomng data.
Ths s partcularly mportant where the sendng devce s capable of sendng
data much faster than the recevng devce can receve t.
Redirection After bIOS POST
Ths settng determnes whether or not to keep termnals?console redrecton
runnng after the BIOS POST has booted.
Terminal Type
To operate the system’s console redrecton, you need a termnal supportng
ANSI termnal protocol and a RS-232 null modem cable connected between
the host system and terminal(s). This setting specifies the type of terminal
devce for console redrecton.
VT-UTF8 Combo Key Support
Ths settng enables/dsables the VT-UTF8 combnaton key support for ANSI/
VT100 termnals.
Sredir Memory Display Delay
Use ths settng to set the delay n seconds to dsplay memory nformaton.
▶
▶
▶
▶
▶
▶
▶
▶