MSI MS-96E3 User Manual
Page 30
Advertising
2-14
Hardware Setup
MS-96E3
Hardware Setup
MS-96E3
c
onnector
Serial ATA Connector: SATA0 ~ SATA3
Ths connector s a hgh-speed Seral ATA nterface port. Each connector can
connect to one Seral ATA devce.
Important
Please do not fold the SATA cable into 90-degree angle. Otherwise, data loss
may occur during transmission.
IDE Connector: IDE1
Ths connector supports IDE hard dsk drves, optcal dsk drves and other IDE
devces.
Important
If you install two IDE devices on the same cable, you must configure the drives
separately to master / slave mode by setting jumpers. Refer to IDE device’s docu-
mentation supplied by the vendors for jumper setting instructions.
Advertising