AT&T Trimline 205 - Manual (Page 14)

12
Handset installation
1. Plug the handset cord into the jack on the lower side of the telephone
base.
2. Plug the other end of the cord into the handset and put the handset on
the telephone base.
3. Lift the handset and listen for
a dial tone. If there is no dial
tone, see
In case of difficulty
(page 15).
NOTES:
• You can make and answer
calls as soon as the
telephone is connected to
a telephone jack.
• If the handset tab on the
telephone base is not
reversed, the handset will
not stay in the telephone
base when mounted on
a wall. If you later move
this telephone to a table
or desk, be sure to reverse
the handset tab again.