Nostalgia Electrics CCP610 - Manual (Page 10)

E
N
G
LI
S
H
8
Assembly of Wheels
1.
Slide one #6 Flat Washer onto Axle Bolt (F) and insert Axle Bolt (F) into Wheel (G).
2. Put on one #7 Flat Washer, and insert Axle Bolt (F) with Wheel (G) into Base Support (I).
3. Add a second #7 Flat Washer and #8 Nut Cap. Use Wrench (H) to tighten the #8 Nut Cap.
4. Repeat steps to attach second Wheel (G) onto the other side of the Base Support (I).
Assembly of Main Unit
1. Place Main Unit (A) onto the top of the Storage Compartment (C).
2. Ensure that the two inserting pins at the bottom of the Main Unit (A) line up correctly
so that Main Unit (A) can be locked under the beam of the Storage Compartment (C).
(F)
Axle
Bolt
(#6)
Flat
Washer
(#7)
Flat
Washer
(I)
Base
Support
(G)
Wheel
(#8)
Nut
Cap