En g li s h – Nostalgia Electrics CCP610 User Manual
Page 9
E
N
G
LI
S
H
7
Assembly of Base Support
1.
Attach Push Handle (E) to Storage Compartment (C) using four #1 Screws. Attached Door
Magnet (P) to inside of Storage Compartment using two #9 Screws and two #10 Nuts.
2.
Insert Cross Bar (J) into the square inserts on the inside of Base Support (I) and
secure from below with two #2 Screws. Place Leg Assembly (K) between the
ends of Base Support (I), and fasten from inside with two #4 Bolts, two #5 Flat
Washers, and two #8 Nut Caps. Also secure from above with two #2 Screws.
3.
Attach bottom of Concession Stand (O) to Bottom Plate (M) using three #11 Screws.
NOTE: Battery for lighted Concession Stand is located on the bottom side of the
Concession Stand. When replacing the AA batteries, be sure polarity is correct (i.e.
match (+) end of battery to (+) end of battery pack) or steps will not light.
4.
Attach Bottom Plate (M) to Base Support (I) assembly using four #2 Screws.
Align Storage Compartment (C) assembly with legs of Base Support (I) and
secure from top using four #3 Bolts. Attach top of Concession Stand (O) to
interior of Storage Compartment (C) and secure with three #11 Screws.