Installing the casters, Installing the guardrail, En g li s h – Nostalgia Electrics KRS2100 SERIES User Manual
Page 11
E
N
G
LI
S
H
9
INSTALLING THE CASTERS
Follow the steps below to install the Casters.
Note: Two of the Casters include locking
mechanisms to ensure the unit does not
slide on hard floors. These two locking
Casters should be fastened at the front
end of the unit, with the unlocked
Casters fasted on the rear end.
1.
Empty the inside of the cabinet
completely and lay the KEGORATOR™
down on it’s side. We recommend
that you place a piece of cardboard
or cloth underneath the cabinet to prevent dents or scratches.
2.
Place washers over Caster bolts, then insert the Casters into the holes
on the bottom corners of the cabinet. Tighten each Caster by turning
the nut clockwise with a wrench (not provided in the kit).
3.
Once all four Casters have been tightened, stand the cabinet in its upright position.
INSTALLING THE GUARDRAIL
Follow the steps below to install the Guardrail.
1.
Place the Guardrail on top of the KEGORATOR™.
2.
Align all holes of the Guardrail with the
holes on the top of the KEGORATOR™.
3.
Secure the Guardrail to the KEGORATOR™
by placing inside corresponding holes.
Beer
Dispenser
Tower
Beer Duct
Guard Rail
Handle