Nostalgia Electrics KEG6000BLK - Manual (Page 10)

E
N
G
LI
S
H
8
KEGORATOR SETUP:
Tap Tower, Coupler & Regulator
INSTALLING THE TAP TOWER
Tap Tower Assembly: Screw Handle to Faucet, and Faucet to the
top of the Tap Tower, as shown below. To complete tower assembly,
screw the Copper Tube into the bottom of the Tap Tower.
After installing the casters, place the rubber beer Tap Tower Washer (A) over the hole in
the top of your kegorator. Feed the Tap Tower hose line through the hole, and line up
the holes in the washer with the holes in the kegorator and those in the base of the Tap
Tower. Using the four screws provided, attach the Tap Tower to the top of the kegorator.
Slide Tap Tower Washer (B) up the Tap Tower hose, followed by the large Tap Tower Nut.
Screw in place until about an inch of the threaded end sticks out in the main compartment
of the kegorator. Attach the handle of the Tap Tower by twisting it into place.
Tap Tower
Washer A
Tap Tower
Washer B
Tap Tower Nut
Screw Screw
Screw
Screw
Copper
Tube
Handle
Faucet