How to operate, En g li s h – Nostalgia Electrics CRF170 RETRO RED User Manual

Page 10

Advertising
background image

E

N

G

LI

S

H

8

HOW TO OPERATE

Before first use, remove all adhesive tape from the drawers, shelves

and trays. Clean the refrigerator thoroughly by wiping the outside with

a soft, dry cloth and the interior with a clean, damp cloth.

Allow the unit to stand upright for 4 hours prior to plugging in. This will reduce the

possibility of the cooling system malfunctioning due to improper handling.

INSTALLATION

1.

The refrigerator should be placed on a completely flat surface. Allow 1 foot of space

on each side of the refrigerator and between the refrigerator and the wall. Also allow

at least 8 inches of space between the top of the refrigerator and the ceiling.

2.

Choose a location for your refrigerator that is not exposed to sunlight, high temperature

or humidity, as humidity may stain and damage the refrigerator. The refrigerator is

not designed to be installed in an outside area, such as a garage or a porch. Ambient

temperatures of below 50ºF or above 89ºF will hinder the performance of this appliance.

3.

The appliance can be adjusted by rolling the two legs in the bottom front of the refrigerator

if it becomes unstable. Raise the refrigerator by rolling the two legs clockwise.

4.

The surface of the location where the refrigerator is installed should be firm

and flat. If refrigerator is not secured in a proper location, noise and vibration

may occur. The noise may be increased if the floor is not firm. If you have

to position the refrigerator on a carpeted floor, place a sheet underneath

the refrigerator to prevent heat emissions from ruining the carpet.

5.

Make sure that legs are pressed firmly into the floor and allow the refrigerator

to lean backward slightly so that the doors remain closed.

6.

Insert the power supply cord into the socket.

7.

The internal temperature of your refrigerator is controlled by the thermostat control

dial. There are 7 settings. Position 7 makes the Refrigerator coldest. Position 1 makes

it the warmest. The freezer may not operate at the correct temperature if it is in a

particularly hot thtemperature, or if you open the freezer doors repeatedly.
NOTE: If you unplug the refrigerator, wait 3-5 minutes before restarting.

The unit may fail to operate properly if restarted too quickly.

PLACEMENT OF FOOD

1.

There should always be some space between items inside for air circulation.

2.

Food should be kept in sealed containers to avoid becoming

dry, spoiled or creating odors in the refrigerator.

3.

Hot food should be cooled down before placing into the

appliance. Otherwise, bacteria will grow in food.

4.

Reducing the frequency of opening the doors can lower the electronic consumption.

5.

If unit fails to cool properly, dispose of spoiled food immediately.
NOTE: Do not use any electronic equipment inside the appliance.

ADJUSTING TEMPERATURE

The internal temperature of your refrigerator is controlled by the thermostat control

dial. There are 7 settings. Position 7 makes the refrigerator coldest. Position 1 makes it

the warmest. To adjust the temperature, turn the dial to the preferred setting. Position 0

Advertising