Grounding the unit, En g li s h – Nostalgia Electrics RMO400 SERIES User Manual

Page 8

Advertising
background image

E

N

G

LI

S

H

6

GROUNDING THE UNIT

This appliance must be grounded. This microwave oven is equipped with a cord having

a grounding wire with a grounding plug. It must be plugged into a wall receptacle that

is properly installed and grounded in accordance with the National Electrical Code

and local codes and ordinances. In the event of an electrical short circuit, grounding

reduces risk of electric shock by providing an escape wire for the electric current.

WARNING: Improper use of the grounding plug can result in a risk of electric shock.

ELECTRICAL REQUIREMENTS

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected

electrical supply. It is recommended that a separate circuit serving only this

appliance be provided. The oven is equipped with a 3-prong grounding plug. It

must be plugged into a wall receptacle that is properly installed and grounded.

Should you only have a 2-prong outlet, have a qualified electrician install a correct

wall receptacle. A 3-prong adapter may be purchased and used temporarily if local

codes allow. Follow package directions. A short power-supply cord is provided

to reduce risk of becoming entangled in or tripping over a longer cord.

EXTENSION CORD

If it is necessary to use an extension cord, use only a 3-wire extension cord that

has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on

the microwave oven. The marked rating of the extension cord should be AC 115-

120 volt, 15 amp. or more. Be careful not to drape the cord over the countertop

or table where it can be pulled on by children or tripped over accidentally.

NOTE: If you have any questions about the grounding or electrical instructions,

consult a qualified electrician or service person. Nostalgia Electrics™ cannot

accept any liability for damage to the oven or personal injury resulting

from failure to observe the correct electrical connection procedures.

RADIO OR TV INTERFERENCE

Should there be any interference caused by the microwave oven to your radio or TV,

check that the microwave oven is on a different electrical circuit, relocate the radio or TV

as far away from the oven as feasible or check position and signal of receiving antenna.

Advertising