Sioux Chief Linear Shower Drain - StreamLine - Manual (Page 8)

7 www.siouxchief.com
Drain at Partial Width Curb
Flashing must turn up the walls a minimum of 3”
above shower curb and 6” above floor in showers
without curbs.
Prior to installing flashing, install pre-formed
outside corners (available separately) following
manufacturer’s instructions. 2 per side.
Measure width of shower floor across drain base.
Measure up and over curb. Lay flashing flat. Measure
and mark flashing.
Cut, fold and crease to proper size and fit.
Note: Do not secure flashing at this time.
Note: Preformed curbs may also be used. See manufacturer’s instructions.
Drain at Full Curb Entry
Flashing must turn up the walls a minimum of 3"
above shower curb and 6" above floor in showers
without curbs.
Prior to installing flashing, install pre-formed
outside corners (available separately) following
manufacturer’s instructions. 2 per side.
Measure width of shower floor across drain base.
Measure up and over curb. Lay flashing flat. Measure
and mark flashing.
Cut, fold and crease to proper size and fit.
Note: Do not secure flashing at this time.
Note: Preformed curbs may also be used. See manufacturer’s instructions.
Inside Shower
7. Prepare Flashing
(cont.)
Inside Shower
Outside Corners
Under Flashing
6" min.
Outside Shower
Outside Corners
Under Flashing
3" min.
Tuck or Fold
6" min.
Outside Corners
Under Flashing
Outside Shower
3" min.
Outside Corners
Under Flashing
Installation Guide