Sioux Chief Linear Shower Drain - StreamLine - Full Mortar Bed - Manual (Page 3)

Drain Sizes
Confirm Drain Size, Waste Pipe
Type and Waste Pipe Location
Drain hole is off-set to accomodate floor joist
location.Size of shower determines size of drain
to be used, which determines location of waste
pipe through sub-floor. Match 2" I.D Schedule 40
pipetype (PVC or ABS) to drain base type.
Pre-Planning
Be certain to gather all required tools and materials
required prior to installation.
Sub Floor Caution: Sub floor must meet local code
requirements and Tile Council of North America (TCNA)
guidelines. Clean sub floor to be sure it is smooth and level.
Pre-Sloped and Full Mortar Bed Requirements
Follow manufacturers instructions. Use products
recommended for the type of sloped bed being installed.
StreamLine Linear Drain assembly is intended to install tight
to toe plate and studs within shower prior to installation of
mortar bed, backer board, waterproofing and tile.
Typical Drain Locations
Note: If connecting two linear drains together, refer to StreamLine
Linear Drain Strainer Connector Kit Instructions for planning and lay-out.
Drain at
Back Wall
Flush to back
wall. Layout 1
Slope
Drain at Full
Curb Entry
Flush to curb.
Layout 2
Drain at
Curb-less
Entry
Flush to both
side walls.
Layout 4
Drain at
Partial Width
Curb
Flush to curb.
Layout 3
Drain On
Center
Flush to both
side walls.
Layout 5
If StreamLine Linear Drain assembly is installed inside toe
plates within shower, add a properly sloped mortar bed to
fill the space between the toe plates and the drain base.
Waste Pipe
Location
15-3/4"
24"
1-1/4"
2-1/4"
1-3/8"
1-7/16"
1-1/2"
1-9/16"
1-5/8"
19-1/2"
32"
23-3/4"
40"
27-3/4"
48"
30-3/4"
54"
33-3/4"
60"
www.siouxchief.com 2
Waste Pipe
Location
Fill
Fill
Installation Guide