Sioux Chief StrongArm with PEX Bend LockBlock Bracketing System - Manual

1
4
2
5
3
6
Working from the back of the
bracket, insert fl exible tube
through the nose of the front
block then bend tube and
capture in place at tail end of
elbow.
Slide plastic elbow block
assembly to desired stub out
location. Insert two screws
into each block and tighten.
Tightening screws prevents
lateral movement of blocks on
brackets and prevents elbow
from swiveling.
As close as possible to each
block, bend the bottom bracket
downward. Bending the bottom
bracket provides the most rigid
installation.
Secure each side of bottom
bracket to stud.
Installation complete.
Determine stub out height.
Secure top bracket to face of
stud bay.
1-800-821-3944 • www.siouxchief.com
#IS-525-PB
©2010 SIOUX CHIEF MFG.
Strong Arm
™
with Plastic Bend Support
Instruction Sheet
Patent # 8,141,831
Patent # 8,061,390