Vogels PFW 6870 - Manual (Page 10)

PFW 6870
Page 10 Installation Instructions
Universal Washer Installation
Vogel's’ Universal Washers are designed to
accommodate the various M4, M5, M6 and M8 hole
sizes required by flat-panels.
Do not place excessive pressure on the back of
the flat-panel, as this may damage your flat-panel.
The Universal Washer must be installed between
the head of the mounting screw and the mounting
bracket as shown.
Does your flat-panel have:
●
Recessed mount points?
●
Uneven mount points?
●
A curved back?
●
Any obstruction near the mount point?
If Yes, you must install Universal Spacers. Remove the
mounting brackets, Universal Washers, and mounting
screws from the back of the flat-panel. Proceed to the
“Universal Spacer Installation” section.
If No, skip to the “Attaching the Mounting Bracket
to the Flat-Panel” section.
Universal Spacer Installation
Vogel's’ Universal Spacers allow you to attach the
mounting bracket to flat-panels which have recessed or
uneven mount points. Each Universal Spacer adds ¼˝
to the distance between the mounting bracket and your
flat-panel.
The Universal Spacers must be stacked and
oriented as shown.
The Universal Spacers must only be installed
between the mounting bracket and your flat-panel.
Proceed to the “Attaching the Mounting Bracket to
the Flat-Panel” section.
M8
M5, M6
M4
1˝ ¼˝
Installing the Mounting Bracket (cont’d)
Flat-Panel
Universal Washer
Universal Spacer
Mounting Bracket
Mount Point
Mounting Screw
The Universal Spacers
Fit M4, M5, M6 and M8 screw sizes.