Vollrath Cayenne Heated Bain Marie Curved Display Case - Manual (Page 4)

C
ountertop
C
ooking
e
quipment
O
peratOr
’
s
M
anual
4
t
roUbleShooting
t
roubleshooting
C
hart
problem it might be caused by Course of action
Light bulb not working. Faulty outlet. Have outlet replaced by qualified personal.
Unit not heating. Faulty heating element. Have unit serviced by qualified personal.
Light bulb not working. Faulty light bulb. Replace light bulb.
S
ervice and
r
epair
The only user serviceable part for this appliance is the light bulb. To avoid serious injury or damage, never attempt to repair the equipment or replace a
damaged power cord yourself. Do not send equipment directly to the Vollrath Company. Please contact the qualified professional repair service listed below.
VOllRATh Technical service • 1-800-628-0832
1. Unplug the equipment.
2. Allow the equipment to cool completely before cleaning. If necessary
follow the procedures for draining water in WET OPERATiOn section of
this document.
3. Using a damp cloth, sponge dipped in soapy water to clean the
equipment.
4. Completely dry the equipment.
m
aintenance
Replacement of the light bulb.
1. Turn off and unplug the equipment.
2. Allow the lights to cool completely.
3. The light bulb is held in place under spring tension. To remove the light
bulb, push the light bulb towards one end this will release the other end.
Lift the lamp out of the holder.
4. Remove and discard the old light.
note:
a halogen bulb should not be touched even when taking
it from the package because the quartz surface can be
damaged by skin oils and salt. this causes the bulb to
fail prematurely. you should use cotton gloves or a cotton
cloth to hold the bulb.
if a halogen bulb does come in contact with your skin,
you can gently clean the bulb surface with an alcohol-
based liquid.
5. To install the light bulb, push the light bulb towards one. Align the other
end into the bulb holder and slowly release the light bulb.
c
leaning
To maintain the appearance and increase the service life, clean your
equipment daily.
WarninG
Burn hazard.
Do not touch hot food, liquid or heating surfaces
while equipment is heating or operating.
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling. Do not drop or spill water onto the cooking surface
as it can spray or splatter.
note:
Do not use cleaning products containing aggressive
chemicals, acids, or that contain chlorine.
WarninG
Electrical shock hazard.
Keep water and other liquids from entering the
inside of the equipment. Liquid inside the equipment
could cause an electrical shock.
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical
shock. Do not use equipment if power cord is damaged or has been
modified
note:
Do not immerse the cord, plug or equipment in water
or any other liquid. Do not use a hose to clean this
equipment.