Kodak D4000 - Manual (Page 13)

Setting Up the Printer
1-9
d. Remove the paper band from the ribbon.
e. Push the end of the take-up spool against the
spring-loaded spool holder. Insert the other end of the
take-up spool through the hole in the cassette frame.
IMPORTANT: Slack in the ribbon can cause a paper jam.
f. Remove any slack in the ribbon by turning the supply spool.
11. To load the new ribbon into the right cassette (labeled R2):
a. Remove the plastic wrapper from the new ribbon. Do not
remove the paper band.
b. Align the bar code end of the supply spool over the label
that shows the bar code position on the cassette.
c. Push the non-bar code end of the supply spool against the
spring-loaded spool holder. Insert the bar code end of the
supply spool through the hole in the cassette frame.
d. Remove the paper band from the ribbon.
e. Push the end of the take-up spool against the
spring-loaded spool holder. Insert the other end of the
take-up spool through the hole in the cassette frame.
IMPORTANT: Slack in the ribbon can cause a paper jam.
f. Remove any slack in the ribbon by turning the supply spool.