Direct printing (pictbridge) problems – Kodak Z710 User Manual
Page 54
48
www.kodak.com/go/support
Troubleshooting
Direct printing (PictBridge) problems
Picture is too light
■
Reposition camera to reduce the amount of available light.
■
Turn flash off (
).
■
Move so that the distance between you and the subject is within the
effective flash range (
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
Use P mode to adjust the Exposure.
Picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
Clean the lens (
).
■
Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If
Try one or more of the following
Cannot locate desired picture.
■
Turn on the camera. Make sure the camera is not in
Favorites mode.
■
Use the Direct print menu to change the image
storage location.
The Direct print menu interface
turns off.
Press any button to redisplay the menu.
Cannot print pictures.
■
Ensure that there is a connection between camera
and printer (
■
Ensure the printer and camera have power.
If
Try one or more of the following