Kodak Z812 IS User Manual
Page 62
56
www.kodak.com/go/support
Troubleshooting
Direct printing (PictBridge) problems
Picture is too light
■
Reposition camera to reduce the amount of available light.
■
Turn flash off (
).
■
Move so that the distance between you and the subject is within the
effective flash range (
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
If using P, A, or S mode, adjust Exposure compensation (
Picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
Clean the lens (
).
■
Make sure camera is not in Close-up/Macro mode if you are more
than 27.6 in. (70 cm) from your subject. (Move further away if you
are using the zoom lens in Close-up/Macro.)
■
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If
Try one or more of the following
Cannot locate desired picture.
■
Turn on the camera. Make sure the camera is
accessing internal memory/card or Favorites.
■
If you are using Direct print, use the menu to change
the image storage location.
The Direct print menu interface
turns off.
■
Press any button to redisplay the menu.
Cannot print pictures.
■
Ensure that there is a connection between camera
and printer (
■
Ensure the printer and camera have power.
If
Try one or more of the following