Kodak M380 - Manual (Page 49)

Troubleshooting
www.kodak.com/go/support 43
Picture quality problems
Direct printing (PICTBRIDGE enabled Printer) problems
Status Solution
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens ( see page 50 ).
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash ( see page 7 ) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 48 .)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
Picture is too light ■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off ( see page 7 ).
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 48 .)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Program and Panorama modes, adjust the Exposure
Compensation (
see page 26 ).
Status Solution
Cannot find the
desired picture ■ Use the Direct printing menu to change the image storage location
(
see page 35 ).