Lenovo ThinkVision Pro2820 28 inch FHD MVA LED Backlit LCD Monitor - Manual (Page 15)

Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Note: The direct access controls are gray.
Table 2-1. Direct access controls
Icon Control Description
Input Change Switches the video input source.
Image Setup Activates automatic image adjustment.
Brightness
Direct access to Brightness adjustment.
Main menu Open main OSD menu
Using the On-Screen Display (OSD) controls
The settings adjustable with the user controls are viewed through the On-Screen Display (OSD),
as shown below.
To use the controls:
1. Press to open the main OSD menu.
2. Use or to move among the icons. Select an icon and press to access that
function. If there is a sub-menu, you can move between options using
or , then
press to select that function. Use or to make adjustments. Press to
save.
3. Press to move backwards through the sub-menus and exit from the OSD.
4. Press and hold for 10 seconds to lock the OSD. This will prevent accidental adjustments
to the OSD. Press and hold for 10 seconds to unlock the OSD and allow adjustments to
the OSD.
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold the buttons for
10 seconds to
disable/enable DDC/CI function. The words " DDC/CI Disable/DDC/CI/Enable" shows on the
screen.
2-3 ThinkVision Pro2820 Flat Panel Monitor User’s Guide