Lenovo ThinkStation P300 - Manual (Page 135)

• To complete the installation or replacement, go to “Completing the parts replacement” on page 123.
Completing the parts replacement
After completing the installation or replacement for all parts, you need to reinstall the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to “Using the Setup Utility program” on page 37.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. See “Locating components” on page 5 for the locations of various components in
your computer.
2. If you have removed the front bezel, reinstall it.
3. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables off the
hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
4. Press the release tab 1 as shown and pivot the drive bay assembly downward until it snaps into position.
Figure 85. Pivoting the drive bay assembly downward
Chapter 9 . Installing or replacing hardware 123