System board components – Lenovo ThinkServer RD340 User Manual
Page 50
• If you are using a ThinkServer RAID 700 Adapter, do the following:
1. Use one mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector
3
on one end of the
cable to the ports 3-0 on the RAID card. Then, connect the mini-SAS connector
4
on the other end
of the cable to the mini-SAS ports 0-3 on the backplane.
2. If your server has more than four hard disk drives installed, use the other mini-SAS to mini-SAS signal
cable. Connect the mini-SAS connector
1
on one end of the cable to the ports 7-4 on the RAID
card. Then, connect the mini-SAS connector
2
on the other end of the cable to the mini-SAS ports
4-5 or mini-SAS prots 4-7 on the backplane.
• If you are using a ThinkServer RAID 710 Adapter, do the following:
1. Use the mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector
1
to the port 1 on the
RAID card. Then, connect the mini-SAS connector
2
to the mini-SAS ports 0-3 on the backplane.
2. If your server has more than four hard disk drives installed, use the other mini-SAS to mini-SAS
signal cable. Connect the mini-SAS connector
3
to the port 2 on the RAID card. Then, connect the
mini-SAS connector
4
to the mini-SAS ports 4-5 or mini-SAS ports 4-7 on the backplane.
Refer to the following topics for information about the connector locations:
•
“Hot-swap hard-disk-drive backplane” on page 33
•
•
“System board components” on page 38
System board components
The following illustration shows the component locations on the system board.
38
ThinkServer RD340 User Guide and Hardware Maintenance Manual