Alloy Computer Products 16-PORT GIGABIT WEB SMART SWITCH GSS-16T2SFP - Manual (Page 16)

10
2-1-2-1. Cabling Requirements for TP Ports
⇒ For Fast Ethernet copper network connections
 The Cable must be Cat. 5 or Cat. 5e with a maximum length of 100 meters.
⇒ Gigabit Ethernet copper network connection
 The Cable must be Cat. 5 or Cat. 5e with a maximum length of 100 meters.
Cat. 5e is recommended.
2-1-2-2. Cabling Requirements for 1000SX/LX SFP Module
There are two categories of fiber, multi mode (MM) and single mode (SM). The
later is categorized into several classes by the distance it supports. They are SX, LX,
LHX, XD, and ZX. In terms of physical connectors for SFP modules, there currently
is only LC and WDM SC types
 Gigabit Fiber with multi-mode LC SFP module
 Gigabit Fiber with single-mode LC SFP module
 Gigabit Fiber with WDM SC 1310nm SFP module
 Gigabit Fiber with WDM SC 1550nm SFP module
The following table lists the types of fiber that are supported. Others not listed
here may be support upon request.
Multi-mode Fiber Cable and Modal Bandwidth
Multi-mode 62.5/125 µm Multi-mode 50/125 µm
Modal
Bandwidth
Distance
Modal
Bandwidth
Distance
160MHz-Km 220m 400MHz-Km 500m
IEEE 802.3z
Gigabit Ethernet
1000SX 850nm
200MHz-Km 275m 500MHz-Km 550m
Single-mode Fiber 9/125 µm
Single-mode transceiver 1310nm 10Km, 40Km
1000Base-
LX/LHX/XD/ZX
Single-mode transceiver 1550nm 50Km, 80Km
TX(Transmit) 1310nm
Single-Mode
*20Km RX(Receive) 1550nm
TX(Transmit) 1550nm
1000Base-LX
Single Fiber
(WDM SC)
Single-Mode
*20Km
RX(Receive) 1310nm
Table2-1