Alloy Computer Products 16-PORT GIGABIT WEB SMART SWITCH GSS-16T2SFP - Manual (Page 24)

18
4-2-2. Ports Configuration
Function name:
Port Configuration
Function description:
Port Configuration allows changing of the various port settings.
Parameter description:
Mode:
Set the speed and duplex of the port.
- If the media is 1Gbps fiber, then there are three modes to choose from:
Auto Speed, 1000 Full and Disable.
- If the media is TP (copper), then there are additional Speed/Duplex
settings. Speed modes = 10,100 or 1000Mbps, and duplex modes = full
duplex or half duplex. The following table summarizes the functions that
each media type supports.
Media type NWay Speed Duplex
1000M TP ON/OFF 10/100/1000M Full for all, Half for 10/100
1000M Fiber ON/OFF 1000M Full
In Auto Speed mode, there is no default values.
In Forced mode, default values depend on your settings.
Flow Control:
Select from either Enable or Disable for Flow Control. If flow control is set to
Enabled, then both parties can send PAUSE frames to the transmitting
device(s) if the receiving port is too busy to handle the data rate being sent
to it. When it is set to Disabled, then there will be no flow control on the port.
In congested situations the switch will drop packets. Default State : Enable
Fig. 4-4