APC SMART-UPS RT SURTA48XLBPJ - Manual (Page 2)

Pre-installation Procedure
2 Smart-UPS RT SURTA48XLBP/SURTA48XLBPJ External Battery Pack User Manual
4. Place the battery pack where it will be used.
– Ensure that air vents on the front and rear of the unit are not blocked.
– Do not operate the battery pack where there is excessive dust or the temperature or humidity
are outside the specified limits.
Pre-installation Procedure
1. Once the battery pack is at the installation site, remove the top cover  and battery modules 
to lighten the load and prepare the battery pack to be installed in a tower or rack-mount
configuration.
2. To disengage the battery from the chassis, push the battery tabs  inward.
3. Go to the installation procedures to install the UPS and battery pack as a tower  (page 3) or in a
rack-mount  (page 5) configuration.
2.5
cm
2.5
cm
40°C
104°F
0%
95%
 

 