AT&T 7402 - Manual (Page 21)

Select Button
To use either of the
features that require the
Select button (
Select )
1 Choose either of the following after pressing
Select :
Press Drop
Test
to initiate a self-test of your voice
terminal lights and ringer. For procedures, see
‘‘Self-Test’’ in this section.
Press Conference
Ring
to select one of 8 personalized
ringing patterns for your voice terminal. For
procedures, refer to ‘‘Select Ring’’ in this section.
Select Ring and Ringer Volume
To select a personalized
ring 1 Press Select (while on-hook)
Green light goes on
2 Press Conference
Ring
Green light next to Select flutters
Current ring pattern plays and repeats every
4 seconds
3 Continue to press Conference
Ring
to cycle through all
8 ringing patterns
4 When you hear the desired ringing pattern, press
Select again
Your new ring is set. Light next to Select
goes off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
begin again. If you lose power after selection, you
will also have to select your ring pattern again.
To adjust ringer volume
if necessary (speaker
must be off) 1 To raise the volume, press the right half of the
Volume control button labeled
. To lower the
volume, press the left half of the Volume control
button labeled
.
17