Set snmp trap auth, Set snmp trap enable frame-relay – Avaya X330WAN User Manual
Page 122
Chapter 6
X330WAN CLI Commands
100
Avaya X330WAN User’s Guide
Example
•
To add an entry to the SNMP trap receiver table:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42
SNMP trap receiver added.
•
To enable SNMP vlan_violation traps to a specific manager:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42 enable
vlan_violation
SNMP vlan_violation change traps enabled.
•
To enable all traps to a specific manager:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42 enable all
All SNMP traps enabled.
•
To disable SNMP vlan_violation traps to a specific manager:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42 disable
vlan_violation
SNMP vlan_violation traps disabled.
set snmp trap auth
Use the
set snmp trap auth
commands to enable/disable the sending of SNMP
traps upon SNMP authentication failure.
Syntax
set snmp trap
{enable|disable} auth
Example
X330WAN-2DS1-1(super)# set snmp trap enable auth
Authentication trap enabled
set snmp trap enable frame-relay
Use the
set snmp trap enable frame-relay
command to enable the DLCI link
state SNMP traps. The traps are disabled by default.
Syntax
set snmp trap enable frame-relay
Example
X330WAN-2DS1-1(super)# set snmp trap enable frame-relay
vlan_violation
(Optional) Specify the VLAN violation trap from the TRAP-
MIB.