Konica Minolta bizhub 421 - Manual (Page 8)

Network Configuration 4
AU-211P 53
4 Network Configuration
It is recommended that a qualified Network Engineer perform the network
configurations. Before beginning this portion of the installation procedure the
individual performing these steps must meet the technical requirements for
the CAC/PIV solution and complete the on-line training module. Please refer
to the service training area of the Learning Place.
NOTE: The completed Installation Survey & Checklist will be required for
this section!
This section will cover the following network settings;
- Configuring network settings IP address and DNS, (page 55)
- Registering Active Directory for authentication (page 57)
- Correcting the MFP time (page 58)
- Registering the DNS server associated with Active Directory
(page 59)
- Specifying the CAC mode or PIV transitional mode (page 62)
- Configuring settings for verifying the Active Directory certificate
(page 63)
Soft Switch Verification:
Please verify the mandatory and optional soft switch settings for the specific
MFP you are now configuring for the network.
bizhub C353 series
MFP Generic Screen Settings
If during the reboot of the MFP you see the generic ‘Globes’ screen
instead of the Blue Konica Minolta Logo you will need to make a soft switch
setting change.
- Enter Service Mode
- Enter System 2-> Soft Switch Settings
- Switch No. 10
- HEX Assignment 00 (generic screen)
- HEX Assignment 02 (Konica Minolta Logo screen)
- Press Fix
Network Environment Settings
The following soft switch setting is manditory
- Enter Service Mode
- Enter System 2-> Soft Switch Settings
- Switch No. 41
- Bit Assignement 00011000
Enable PrincipleName ‘ user @mil’ & FQDN