4 administrator settings (g3), 1 system settings - power save settings, Administrator settings (g3) -14 – Konica Minolta BIZHUB 223 User Manual
Page 226: System settings - power save settings -14, P. 10-14), Fax] (p. 10-14)
bizhub 423/363/283/223
10-14
10.4
Administrator Settings (G3)
10
10.4
Administrator Settings (G3)
This section describes administrator settings that are configured for G3 Fax TX. The descriptions in this sec-
tion also apply to Network Fax.
10.4.1
System Settings - Power Save Settings
Specify the condition for which the machine shifts to the power save mode, and whether to enable the power
save mode for the fax board.
10.4.2
System Settings - Output Settings - Print/Fax Output Settings - Fax
Specify the printing method for RX documents.
-
[Batch Print] (default): Printing is started after all documents are received.
-
[Page Print]: Printing is made each time a page of document is received.
Item
Description
[Enter Power Save
Mode]
Select the condition on which the machine shifts to the power save mode.
•
[Normal]: When a fax is received during the power save mode, the fax job
is printed. After a predetermined time has elapsed, the machine shifts to
the power save mode.
•
[Immediately] (default): When a fax is received during the power save
mode, the fax job is printed and then the machine immediately shifts to
the power save mode.
[Fax Board Power Save]
Specify whether to enable the power save mode for the fax board.
•
Even when [Yes] is specified, the fax board does not shift to the power
save mode if the Number of RX Call Rings is set to 0.