Konica Minolta BIZHUB 223 - Manual (Page 15)

bizhub 423/363/283/223 2-3
2.1 Accessing the Administrator Settings 2
3
Enter the 8-to-16-digit Administrator Password from the keyboard or keypad.
% Press the [C] key to clear all characters.
% Touch [Delete] to delete the last character entered.
% Touch [Shift] to show the upper case/symbol screen.
% Touch [Cancel] to go back to the screen shown in step 2.
4
Touch [OK].
% If a wrong Administrator Password is entered, a message that tells that the Administrator Password
does not match appears. Enter the correct Administrator Password.
% If Prohibited Functions When Authentication Error is set to [Mode 2], entry of a wrong password is
counted as unauthorized access. If a wrong Administrator Password is entered a predetermined
number of times (once to five times) or more set by the Administrator of the machine, a message
appears saying that the machine accepts no more Administrator Passwords because of unautho-
rized access for any subsequent entry of the Administrator Password. The machine is then set into
an access lock state. To cancel the access lock state, settings must be made by the Service Engi-
neer; or, turn off, and then turn on, the main power switch of the machine. If the main power switch
is turned off and on, the access lock state is canceled after the lapse of time set for [Release Time
Settings]. When the main power switch is turned off, then on again, wait at least 10 seconds to turn
it on after turning it off. If there is no wait period between turning the main power switch off, then on
again, the machine may not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch
→ Turn on the sub power switch
5
Press the [Utility/Counter] key to log off from the Administrator Settings.