Konica Minolta bizhub PRESS 1052 - Manual (Page 20)

bizhub PRESS 1250/1250P/1052 3-3
3.1 Removal Procedures 3
7
Holding the handles on the front [1] and rear [2] of EF-102
with both hands, slide the unit to the direction of arrow,
and then pull it up to remove it.
Be careful in handling EF-102 because it may be very hot.
8
Remove the rear cover from the stored fusing unit.
9
Holding the handles on the front [1] and rear [2] of the fus-
ing unit with both hands, set the unit to the correct posi-
tion, and then slide it to the direction of arrow until it
knocks in place.
10
Push in the lock screw (purple) and rotate the screw to the
direction of arrow to lock the unit.
11
Close the reversing paper exit unit.
12
Return the ADU drawer to its original position, and then reset the lever [M4] upright to lock the drawer.
13
Close the left side door, and then the front door of the main body.
14
Install the rear cover to EF-102 that has been removed from the main body.
NOTICE
Be sure to install the rear cover after EF-102 cools down.
NOTICE
Be sure to use the packaging box of EF-102 for storing the removed EF-102.