Konica Minolta bizhub C10X - Manual (Page 122)

NETWORK SETTING Menu 112
DNS Configure
"
When using network scanning and when specifying the SMTP server
as a host name instead of as an IP address, be sure to select
“
ENABLE ”, and then specify the IP address of the DNS server.
DDNS Configure
Purpose Sets whether or not the DNS server setting is to be speci-
fied.
If specifying the DNS server setting, the SMTP server can
be specified as a host name when using network scanning.
If “ENABLE” is selected, type in the IP address of the DNS
server.
If “DISABLE” is selected, the DNS server cannot be refer-
enced.
Options
DISABLE/ENABLE
Default
DISABLE
Range (If “DNS CONFIG.” is set to “ENABLE”)
0-255 for each xxx triplet
Use the keypad to input each number; use the Left and
Right keys to move between triplets.
Notes A single digit number, such as “1”, cannot be input as “001”.
Align the number on the left and input “1” as “1 _ _”. Use
the * and ) keys to move between triplets.
The Cancel/C key can also be used for deleting. To cancel
DNS Configure menu, hold down the Cancel/C key for
more than one second, and then press the Cancel/C key
again after all settings have been cleared.
After changing the settings, the printer must be turned off,
then on again.
Purpose Enables or disables DDNS (Dynamic Domain Name Sys-
tem).
If ENABLE is selected, DDNS is enabled.
If DISABLE is selected, DDNS is disabled.
Options DISABLE/ENABLE
Default DISABLE