Konica Minolta bizhub C451 - Manual (Page 7)

If you’re configuring the Copier and Fiery with 2 Static IP Address you will need to do the
following:
1. You will need a HUB/ Switch and 3 Patch Cables [RJ45]
2. One Patch Cable connected to the Customer Network
3. One Patch Cable connected from the HUB/ Switch to the Fiery
4. One Patch Cable connected from the HUB/ Switch to the Copier NIC.
Please see picture below.
5. By performing this type of setup you will have 2 independent IP Addresses and utilizing
a bit more hardware.
Note: For the actual Installation [Hardware Installation] please refer to the Fiery’s:
“Video Interface Kit/ Image Controller Fiery X3eTY 50-45C-KM Installation Manual”