Konica Minolta bizhub PRO 1051 - Manual (Page 324)

Utility Tool 13
bizhub PRO 1200/1200P/1051 Printer 13-24
!
Detail
Refer to the Novell NetWare manual for details of setup with PCONSOLE
of NDS.
Setup for Bindery Emulation
Make sure of the Bindery Context.
Before connecting the print server (network interface card) to the Novell Net-
Ware 4.x-6 server of Bindery mode, make sure that the NetWare server con-
tains the bindery context.
If the bindery context does not exist, the network administrator should mod-
ify the AUTOEXEC.NCF file to add an adequate SET command and restart
the NetWare server or enter a SET command from the console prompt to
make changes.
Note that any command entered following the console prompt is effective
immediately but the definition of the autoexec.ncf file becomes effective only
after turning off power and on again.
Setup with PCONSOLE in Bindery mode.
If you are sure that the bindery context exists in the file server, you can set
up the print server with PCONSOLE.
!
Detail
Refer to the Novell NetWare manual for details of setup with PCONSOLE.
In Bindery mode, only upper-case letters are valid for the printer server
password.