Konica Minolta Magicolor 2550 - Manual (Page 24)

Selecting Driver Options/Defaults (for Windows) 10
Selecting Driver Options/Defaults
(for Windows)
Before you start working with your printer, you are advised to verify/change
the default driver settings. Also, in case you have options installed, you
should “declare” the options in the driver.
Windows XP/Server 2003/2000/NT 4.0
1
Choose the driver’s properties as follows:
– (Windows XP/Server 2003)
From the Start menu, choose Printers and Faxes to display the
Printers and Faxes directory. Right-click the KONICA MINOLTA
mc2550 PCL6 or KONICA MINOLTA mc2550 PS printer icon and
choose Properties.
– (Windows 2000/NT 4.0)
From the Start menu, choose Settings and then Printers to display
the Printers directory. Right-click the KONICA MINOLTA mc2550
PCL6 or KONICA MINOLTA mc2550 PS printer icon and choose
Properties.
2
If you have installed options, proceed with the next step. Otherwise, skip
to step 9.
3
Select the Configure tab.
4
Check that the installed options are correctly listed. If not, proceed with
the next step. Otherwise, continue with step 8.
5
Click the Refresh to automatically configure installed options.
!"
The Refresh is available only if bi-directional communication is
available with the printer; otherwise it is grayed out.
6
From the Device Options list, select an option, one at a time, and then
select Enable or Disable from the Settings menu.
!"
If Printer Memory is selected, select 128 MB, 256 MB, 384 MB or
640 MB, according to the installed memory. The factory default
setting is 128 MB.
7
Click Apply.
!"
Depending on the version of the operating system, Apply may not
appear. If this is the case, continue with the next step.