Konica Minolta BIZHUB C360 - Manual (Page 32)

bizhub C360/C280/C220 3-2
3.1 Control panel 3
3 Control Panel/Liquid Crystal Display
3.1 Control panel
Use the control panel for User Box mode operation. The following describes the buttons and switches in the
control panel.
No. Name Description
1 Touch Panel Various screens and messages are displayed. Configure the various set-
tings by directly touching the panel.
2 Power Indicator Lights up in blue when the machine is turned on with the main power
switch.
3 Sub Power Switch Press this switch to turn on/off machine operations, including copying,
printing and scanning. When turned off, the machine enters an energy
conservation state.
4 Power Save Press this key to enter Power Save mode. While the machine is in Power
Save mode, the indicator on the Power Save key lights up in green and
the touch panel goes off. To exit from Power Save mode, press the Pow-
er Save key again.
5 Mode Memory Press this key to register (store) the desired copy/scan settings as a pro-
gram or to recall a registered copy/scan program.
6 Utility/Counter Press this key to display the Utility screen and the Meter Count screen.
7 Reset Press this key to clear all settings (except programmed settings) entered
using the control panel and touch panel.
8 Interrupt Press this key to enter Interrupt mode. While the machine is in Interrupt
mode, the indicator on the Interrupt key lights up in green and the mes-
sage "Now in Interrupt mode." appears on the touch panel. To cancel In-
terrupt mode, press the Interrupt key again.
9 Stop Pressing the Stop key during scanning temporarily stops the scan oper-
ation.
1
2
5
4
6
3
7
8
9
14 13 10
15
16
17
18
12 11
19
20
21
22