Konica Minolta BIZHUB C360 - Manual (Page 281)

bizhub C360/C280/C220 10-2
10.1 Error message list 10
10 Appendix
10.1 Error message list
If an error message appears, perform the corresponding operation described below.
d
Reference
For details on the network settings, refer to [User's Guide Network Administrator].
Message Cause and remedy
Unable to connect to the net-
work. Make sure that the network cable is correctly connected. In addition,
make sure that Network Settings in Administrator Settings have been
correctly configured.
The address for the communi-
cation method cannot be select-
ed since the number of
addresses has exceeded the
maximum allowed for broad-
casting. The number of destinations specified exceeds the number possible
for a broadcast transmission. Reduce the number of broadcast desti-
nations, or send the transmission in multiple batches.
Document could not be saved in
user box due to insufficient HDD
capacity. Check log. The hard disk is full. Delete unnecessary data, and then try saving the
data again.
The number of registered user
boxes has reached the max. al-
lowance. The number of registered user boxes has reached the maximum al-
lowed. The number of User Boxes that can be registered has reached
the maximum number possible.
The number of documents
saved in the User Box has
reached its maximum. The number of documents saved in the User Box has reached its
maximum. The number of documents that can be saved in a User Box
has reached the maximum number possible.
The number of programmed
jobs has reached the max. al-
lowance. Wait until a pro-
grammed job is completed. The number of jobs that can be programmed has reached the maxi-
mum number possible. Wait until a job has been completed, or delete
a current job.