Konica Minolta bizhub PRESS C1070 - Manual (Page 48)

4-2
4.1 Loading Paper
E
Slide the rear guide plate to any position.
Determine their locations based on the size indicator of the
bottom plate of the tray.
F
To fix the side guide plates at the correct locations, load an appropriate amount of
paper into the tray while aligning it to the right-hand side of the tray.
NOTICE
NOTICE
Load paper with the print side facing down.
G
Press the side guide plate against the paper.
H
Turn two side guide lock knobs (in the front and
rear sides) clockwise, and fix them.
I
Load the remaining paper into the tray, then press
the rear guide plate against the paper.
NOTICE
NOTICE
Do not load more than 500 sheets (80 g/m
2
/ 21 lb Bond) into Tray 1,
and more than 1,000 sheets (80 g/m
2
/ 21 lb Bond) into Tray 2. Also,
do not load paper above the , mark that indicates the height limit on
the side guide plate. Otherwise, a paper jam may occur.
Be sure that the rear guide plate is securely pressed against the
paper. If there is any gap between the rear guide plate and the
paper, this machine will not be able to detect the correct paper size.
It may cause a paper feeder machine error.
Check paper for kinks. Otherwise, a paper jam may occur.
J
Close the tray.
Push the tray in until it locks into place.
The amount indicator changes from to in the tray information display area of the
[MACHINE] or [COPY] screen.
NOTICE
NOTICE
Carefully close the tray. Otherwise, the machine may be subjected to an unexpected impact due to the tray or
paper weight, which may lead to a machine error.