Konica Minolta magicolor 1600W - Manual (Page 16)

About the Control Panel 1-7
When cleaning the print head window
Hold down the Rotate Toner key for 5 seconds to 9 seconds.
The printer enters Print Head Cleanup mode.
"
For details on cleaning the print head window, refer to “Cleaning the
Print Head Window” on page 6-8.
"
To return to normal operation mode from Print Head Cleanup mode,
refer to “Cleaning the Print Head Window” on page 6-8.
"
Print Head Cleanup mode is a mode that allows the user to clean the
print head window more easily. The print head window is not cleaned
automatically.
When removing all toner cartridges
Hold down the Rotate Toner key more than 10 seconds.
The printer enters Eject All Toner mode.
"
For details on removing all toner cartridges, refer to “Removing All
Toner Cartridges” on page 5-11.
"
To return to normal operation mode from Eject All Toner mode, press
the Clear key.
About the Clear KEY
The Clear key allows you to:
„ Continue a print job after addressing an error message
„ Cancel a print job
„ Reset the printer after a toner cartridge is replaced
"
For details on resetting the printer after replacing a toner cartridge,
refer to “Replacing a Toner Cartridge” on page 5-5.
Continuing a Print Job after an Error Message
You can continue a print job after correcting the following types of errors:
„ No more media in the tray
„ Media other than that set in the printer driver was fed into the printer
"
For details on the error messages, refer to “Indicator Messages” on
page 7-5.