Konica Minolta bizhub C35 - Manual (Page 67)

Faxing manually (G3 fax) 3-22
Faxing manually (G3 fax)
If a fax is sent manually, the status of the recipient can be confirmed before
the fax is sent.
In order to send a fax manually, the following requirements must be met.
„ The document cannot be divided and scanned separately. If the original
glass is being used, the document being sent can contain only one page.
„ F-code transmissions, timer transmissions, password transmissions and
polling reception are not being performed.
„ Automatic redialing cannot be used.
„ Multiple destinations cannot be specified.
The procedure for a manual transmission with [Off-Hook] pressed is
described below.
"
If [Admin Settings] - [Fax Settings] - [Fax Function Settings] - [Cofirm
Addr (TX)] is set to [ON], [Off-Hook] cannot be used.
1
Press [Fax] or press the [Fax] key to display the initial Fax screen.
– For details on the initial Fax screen, refer to “Initial Fax screen” on
page 1-8.
2
Position the document to be faxed.
– For details on loading the original document, refer to “Positioning the
original document” on page 3-4.
3
Press [Settings], and then select the appropriate settings on the [Scan
Settings], [Comm. Settings] and [Original Settings] screens.
– For details on the [Scan Settings] screen, refer to “Specifying scan
settings” on page 3-11.
– For details on the [Comm. Settings] screen, refer to “Specifying com-
munication settings (G3 fax)” on page 3-13 and “Useful transmission
functions (G3 fax)” on page 3-14.
– For details on the [Original Settings] screen, refer to “Specifying docu-
ment settings” on page 3-18.
4
Press [Off-Hook].
5
Make sure that [Send] is selected.
6
Specify the destination.
– Press to select a registered destination.
– Press the [Mode Memory] key to select a program destination.
7
After the fax answer tone is heard, press [Start] or press the [Start] key.
The document is scanned and transmission begins.